1. Place joint · 2. Rotate/Tilt/Size with cutter visible · 3. Check Cut, inspect, or Back to Edit
ROTATE VIEW · joint and cutter together
▤ Place Model on Bed
STEP 2 OF 3 · Position your model
Choose Lay Flat for a quick start or Lay on Face and tap the surface that belongs on the plate. Use the rotations below for adjustments.
Choose a method, then check the model from the side.
Rotate the real model, not just the view. All triangles keep their detail. Existing joints follow the model.
Or choose an exact rotation. The model automatically drops back onto the plate after every move.
Bottom Z: 0 mm
Joint 1
Move X 0
Move Y 0
Move Z 0
2–3 mm joints are experimental: use fine mesh quality, inspect the clearance in your slicer, and test-print before relying on the hinge.
Push / pull0 mm
Raise / lower0 mm
Push / pull0 mm
Move across view0 mm
Joint cross-section
Computed from the actual edited volume, not a decorative joint picture
0 mm
Male axle / ball sideSleeve / socket side
The dark gap should be continuous around moving parts.